Proteus仿真实例，单片机学习的好帮手

最小二乘法拟合用在嵌入式系统的代码,单片机上可以测试过-Least square method used in embedded systems code, single-chip can be tested

ht1621液晶驱动的测试程序，汇编语言编写-HT1621 LCD driver test procedures, assembly language preparation

端口控制发光二极管亮灭。 【硬件连接】通过SPCE061A的1位I/O端口（本例中使用IOA15端口），经一限流电阻后接一个发光二极管至地-Port control to eliminate bright light-emitting diodes. [] Through SPCE061A hardware connection of an I/O port (in this example, the use of IOA15 port), with a current limiting resistor followed by a light-emitting diodes to land

C8051F52xA_53xA型单片机看门狗驱动源代码-C8051F52xA_53xA-based single-chip watchdog driver source code

周立功公司的C51 CANBus开发套件，可应用于CAN BUS的底层驱动开发-the C51 CANBus development kit that can be applied to the bottom of the CAN Bus Driver Development

设置窗口布局的几种手段，可以对比不同显示效果-Settings window layout of several means, you can compare different display

利用AT16的A/D转换功能,测量两点电位差-AT16 use the A/D conversion function, measurement of potential difference to two points

这是一个和proteus结合的 使用gal的实例 和好噢-This is a combination of lic and the use of gal Oh good examples and

这是一套基于单片机的温湿度测量系统，里边附有设计的原理图，pcb图，以及烧写程序代码（keil c51编写的）。温湿度传感器使用的是dht11，性价比高。该系统除了能显示温湿度以外，还能设置温湿度报警阈值。设计的pcb板，小巧，使用。这是本人的毕业设计，有实物为依据，具有可操作性。-This is a single-chip microcomputer-based measuring system of temperature and humidity inside with schematic design, pcb plans, as well as the programmer code (keil c51 prepared). Temperature and humidity sensors are used dht11, cost-effective. Except that the system can display temperature and humidity outside, but also set the temperature and humidity alarm threshold. Pcb board design, compact, use. This is my graduation project, there is the physical basis of operational.

16位单片机对AD9854控制的实现，主要用于凌阳16位单片机