3线双向零等待IO通讯机制 单片机通讯源代码带说明

tlc1543AD转换程序,TLC1543 AD采样子程序-tlc1543AD the conversion process, TLC1543 AD sampling subroutine

51读写硬盘的程序模块,编译完全通过,移植方面,实用.-literacy drives 51 program modules, compile full, transplant and practical.

这是MICROCHIP 的PIC 系列单片机常用 的C语言编译器。特别对PIC16F877系列 特别好用。-It is C compiler for PIC of MICROCHIP,especially for PIC16F877,it is very good!

mifare 读卡器weigant输出有kei uvision打开！-MIFARE reader weigant output is Kei uvision open!

超精简的读写u盘程序，只有180行，可生成文件系统，估计再没有比这更短的程序了把？-Super-streamlined procedures to read and write u disk, only 180 lines, can generate the file system, it is estimated that more There is nothing short of the procedures?

M600单片机的高使用，有关于M600单片机的不常用的但很重要的硬件的使用方法-M600 single-chip high-use, single-chip on the M600 is not commonly used but it is important to use the hardware

用VERILOG语言编写的电子钟程序.是用GW48教学实验箱仿真-Verilog language using an electronic bell procedures. GW48 is teaching me the experimental simulation

用凌阳61单片机实现正弦信号的产生，压缩包中包括原理图和程序文件-Sunplus MCU with 61 of the generated sinusoidal signal, compressed package includes schematic and program files

一个用C51编写的倒计时程序，可通过PC传送起始时间，也可回传当前时间。比较简单-C51 with a countdown of the preparation process, through PCs starting time, but also back- the present time. Relatively simple

PCF8563 的驱动程序，用两个普通的IO口模拟I2C总线，包括100KHZ（T=10US）的标准模式选择和400KHZ的快速模式选择，默认11.0592MHZ的晶振-PCF8563 of the driver, with two ordinary analog IO I2C bus, including the extremely low distortion (T = 10US), the standard model selection and 400KHZ fast mode selection, the crystal default 11.0592MHZ