TFT2.8 lcd +SSD1289 IC init

ALTEA EPM7128 CPLD的用于控制三维步进电机的VHDL源代码-ALTEA EPM7128 CPLD is used to control the stepper motor of three-dimensional VHDL source code

一个用于单片机的键盘驱动程序，用C51编写-One for single-chip microcomputer keyboard driver, using C51 prepared

The ADC0803 family is a series of three CMOS 8-bit successive approximation A/D converters using a resistive ladder and capacitive array together with an auto-zero comparator. These converters are designed to operate with microprocessor-controlled buses using a minimum of external circuitry. The 3-State output data lines can be connected directly to the data bus.

AT89C2051驱动步进电机的电路和源码(用keilC51)-AT89C2051 stepper motor drive circuits and source code (using keilC51)

USB Mouse，已经调试通过，控制芯片为PDIUSBD12,keil编译环境。-USB Mouse, has been testing through the control chip for PDIUSBD12, keil compiler environment.

这是一个输出字节和汉字的程序...可以用的我已调试过的-output byte characters and procedures can be used to ... I have tuned in

本文介绍了ISP程序设计方法，以及在SST和STC单片机上的具体实现方法-This paper introduces the ISP programming method, as well as in the SST and the STC on the concrete realization of single-chip approach

这是一个51单片机与PC的通信系统：利用3*4小键盘输入0~9的一串数字（不大于5），通过8051自带的串口发送给PC并显示在系统的6位LED上；单片机接收上位机的输入并显示在LED上。8051串行口经232电平转换后，与PC机串行口相连。PC机使用串口调试应用程序V2.2.exe，实现上位机与下位机的通讯。-This is a 51 microcontroller and PC communication system : use 3* 4 0 small keyboard input of a bunch of nine-figure (no more than 5), by 8051, bringing their serial sent to the PC and display system in the six LED; SCM receiving PC input and displayed on the LED on. 8,051 by 232 serial port-level conversion, and the PC serial port connected. PC using serial debugging applications V2.2.exe achieve PC and the next crew communications.

这是一个1602液晶的显示程序，基于51单片机，已实验成功-This is a 1602 LCD display procedures, based on 51 single-chip, has conducted successful experiments in

430例程1：液晶显示，键盘扫描，数码关扫描显示等等，还有时钟程序-a 430 routines : LCD, keyboard scanning, digital scan revealed customs and so on, the clock procedures