232模拟串口的程序，给需要的朋友

彭鸿才电机原理及拖动,希望对大家有帮助，共同学习，多多交流-none

是一个G代码转换的源程序，将标准G代码读入后在UG环境下生成加工代码刀具路径。-G is a conversion of source code, to reduce the standard G code read in the UG environment processing code generated tool paths.

ASC 信号机控制程序,国内最先进的信号机控制程序-ASC signal control procedures, the most advanced signal control procedures

51单片机的高速串口驱动ucos ii的移植-51 Single-chip high-speed serial drive ucos ii transplant

一个AduC845实验板的电路图以及实验源代码-ADuC845 experiment a circuit board, as well as experimental source code

AVR单片机软件模拟USB的程序。-AVR USB software simulation procedures.

HT-3000单片机的一个关于LED显示的例程，这种单片机用的人可能不是太多。-HT-3000 MCU an LED display on the routines, the MCU people who may not be too many.

十种软件滤波.rar介绍了十种软件滤波的方法,不过我建议还是使用模拟滤波方法好.-10 kinds of filtering software. Rar introduction of dozens of software filtering method, but I suggest that the use of analog filtering methods or good.

c8051f020串口调试程序,针对c8051系列芯片，这是一个不错的例子噢〉-C8051f020 serial debugging procedures against c8051 series chip, which is a good example Oh>

8*8led屏全方位移动，希望觉得好的就请多加分数给我，-8* 8led full-screen mobile, want to feel good, please give me more points, thank you