采用实时芯片DS1302来计时,并用LCM液晶显示!有较高的精确度!

该源代码运行于89c51系列单片机上,可从输入FLEX二进制码流中解交织,处理CRC纠错,并最终解码出有效ASCII码数据.-the source code running on 89c51 MCU, FLEX can be imported from binary code stream deinterleave handling of CRC error correction. and finally decoding of effective ASCII data.

本例程是MzT35C1 TFT模块在AVR Mega32的芯片平台上实现基本显示功能，如字符和汉字的显示、基本的绘图函数的显示（ 包括绘点、绘直线、绘圆等）-This routine is MzT35C1 TFT module AVR Mega32 chip platform for basic display capabilities, such as characters and Chinese characters are displayed, the display of the basic drawing functions (including the draw point, draw a straight line, draw circle, etc.)

单片机设计的遥控电路，遥控码的脉宽数用红外线接收器解码后送单片机读入，发射时由单片机产生40KHZ红外调制信号送红外线发射管发射-Single-chip design of the remote control circuit, remote control code number of the pulse width decoder using infra-red receiver to read single-chip evacuation, launch generated by single-chip modem 40KHZ IR signal sent to the launch tube fired infra-red.

自己编写的一个单片机控制红外发送与接收的红外接收源程序,同时自己也做了一个板实验,是成功的哦-I have written a single chip to send and receive infrared control infrared receiver of the source, at the same time also made a plate experiment was a success, oh

PIC16F877单片机 Boot-Loader -PIC16F877 microcontroller Boot- Loader

ARM的计数器中断实验。是基于Keil For Arm的。-ARM interrupt counter experiments. Is based on the Keil For Arm.

M25PE10, M25PE20, M25PE40 and M25PE80 这些型号FLASH 的驱动程序-M25PE10, M25PE20, M25PE40 and M25PE80 these models FLASH driver

CAN 驱动编程-CAN-driven programming

一段lcm06xk方面的液晶驱动代码，经过测试证实可用-For some aspects of lcm06xk LCD driver code has been tested to confirm availability

八路电压表C程序 使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管 P1口输出段码，P3口扫描，最高位指示通道（0-7）。-Eight-way voltage meter C program using AT89C52 single-chip, 12MHZ crystal, P0 I read into the AD value, P2 I make AD control, with a total of P1 Yang LED digital tube output above code, P3 port scan, the maximum channel bit instructions (0-7).