C51常用程序库，包含了常用的程序模块和功能，可以直接在设计中参考。...

Msp430的flash读写文件配置文件，(msp430f427芯片)-MSP430

单片机在循环显示数字列的同时，采用查询方式控制数字的显示时间和音乐播放的开关。音乐低频信号由定时器采用中断方式产生。-SCM in circulation figures out show at the same time, using figures for the control of time- and the music player switching. Music low-frequency signals used by the timer interrupt way.

1984-1993模糊 C 源代码竞赛.zip 非常的好,不过这是DOS格式,要用UE去打开.-1984-1993 Fuzzy C source code for race. Zip very good, But it is the DOS format, we should open the UE.

w78e58b isp 源程序,keil v7。10调试通过并应用。-w78e58b isp source, c51 v7. 10 adoption and application debugging.

基于AVR单片机 MEGA16的温度采集源程序，采用ds18b20实现-AVR-based single-chip temperature MEGA16 source acquisition, the realization of ds18b20

单片机C51实战应用集锦，是很好的单片机初学者学习和参考的资料。-C51 single-chip Collection of combat application, is a very good learning and reference for beginners Singlechip information.

利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show

此源码利用单片机实现智能信号发生器，借鉴借鉴。-use of this source SCM intelligent signal generator, use reference.

系统的最小板程序，可以作为其他开发的基础！可以通过键盘控制！-the smallest board procedures, can be used as the basis for other development! Keyboard control can!

关于93C46的读写程序，经过本人的实践成功完成读写功能，希望大家收下-on 93C46 literacy procedure, after I successfully completed the practice of functional literacy, we accept