L298N控制步进电机正反转程序，单片机采用凌阳SPCE061A，连接方式请按程序注释连接，工程可下载直接使用。...

经典的DSP的C程序和汇编程序, 非常好!-Classic DSP-C procedures and compilation of procedures, very good!

声明：本资料仅从技术的角度全面探讨IC卡、IC电话卡及其安全性，由此引发的各种争议或个人、集体利用本资料做任何不正当用途本人概不负责。-statement : This information just from the technical point of the comprehensive study of IC cards, IC cards and safety, has triggered the dispute or individual, collective use of the information to do anything improper purposes, I shall not be responsible for.

大厦LED流水显示的程序，刚刚编完，可通过修改循环的次数和数据表来构成不同的显示效果-LED shows the procedure, the newly produced, cycle through changes in the number and composition of data tables show different results

PROFIBUS-dp PROGRAMS 主从站源程序 -PROFIBUS-dp PROGRAMS source master and slave stations

51系列单片机指令列表，非常详细，对新手有帮助，-51 Series MCU instructions list is very detailed and helpful to newcomers,

C8051F040单片机CAN总线接收和发射程序，简单明了-C8051F040 single-chip CAN-bus to receive and launch procedures, simple

此源码利用单片机实现智能信号发生器，借鉴借鉴。-use of this source SCM intelligent signal generator, use reference.

台湾凌阳单片机SPCE061A单芯片做的一个带按健LCD显示，USB通信的一个类似于MP3的一个产品。不带FAT32的。-Taiwan Sunplus SPCE061A single chip to do with a by-LCD display, USB MP3 similar to the one in a product. Not with the FAT32.

采用MPLAB开发，计算球面坐标到高斯坐标的投影，经度小于1m-Using MPLAB development, calculation of spherical coordinates to Gaussian projection coordinates, longitude less than 1m

TI的S6700芯片与ISO/IEC15693标准的读卡器设计，包括起始位，结束位，数据收发的子程序-TI" s S6700 with the ISO/IEC15693 standard reader chip design, including the start bit, end bit, data sent and received subroutine