Proteus

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

Proteus仿真实例，在Proteus下仿真LCD,可以使用，郑重推荐！-Proteus simulation example, in the Proteus simulation under the LCD, you can use, solemnly recommended!

HDLC协议英文原版。希望对大家有帮助。-English original HDLC protocol. Hope everyone has to help.

本人at89c51snd1c主控IC增加了128*32点阵驱动显示，帮助MP3DIY者学习用-I at89c51snd1c control IC increased by 128* 32 dot matrix display drive to help those who learn MP3DIY

Ocm4x8C 128*64液晶示器驱动程序-Ocm4x8C 128*64 liquid crystal telltale driver

红外－RS232协议转换器电路图适合51系列单片机-infrared-RS232 protocol converter circuit for 51 Series MCU

单片机与液晶屏接口程序，C代码，简单且实用。-MCU and LCD screen interface program, C code, a simple and practical.

基于５１单片机的３２位除法程序-based on the 32-bit microcontroller division procedures

单片机仿真软件proteus做的蜂鸣器例子，有助于在具备硬件情况下学习单片机-microcontroller simulation software lic do buzzer example, with the help of learning hardware MCU

NEC制红外遥控编码解码+LCM44780 LCM显示驱动-NEC IR DECODE+LCD44780 LCM DISPLAY DRIVER