二进制代码的头文件

无线解码程序，是用于多种无线报警主机的解码-wireless decoding procedure is used in a variety of wireless alarm host decoder

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

此为继电器功能测试电路图DDB文件。对应源码为Relay_Function_Tester. keil c51 编写。-This is the relay circuit functional testing DDB file. The corresponding source code for Relay_Function_Tester. Keil c51 prepared.

LT_1B msp430开发板例子程序－UART05_096-LT_1B msp430开发板例子程序－UART05_09600

AVR定时器功能 定时器每秒加一,0到255循环,通过数码管显示计数值-AVR timer function Timer per second, plus one, 0 to 255 cycles, through the LED display counts

基于PSCE061A(凌阳单片机)的语音遥控小车-Based on PSCE061A (Sunplus Singlechip) voice remote control car

该 程序 ADUC824-The program ADUC824

单片机定时中断的精确定时编程　里面介绍了５种定时中断的方法误差均不超过1个机器周期-SCM regularly interrupted regular programming precision inside of five species regularly interrupted the error not more than one machine cycle

mcs51平台的SA866AE控制程序．用I/O口模拟spi，高质量代码．-mcs51 platform SA866AE control procedures. With I/O port simulation spi, high-quality code.