Single

双STF16360EN驱动点阵VFD显示-Dual-drive dot matrix VFD display STF16360EN

开发环境:ADS 1.2 目标平台:ARM:S3C44B0 显示屏:tft4.3" 480*272(24Bit) GUI:UCGUI324 项目功能:实现UCGUI在ARM7和彩屏LCD上成功移植 Seloo@tom.com 2008-10-12-Development Environment: ADS 1.2 target platforms: ARM: S3C44B0 display: tft4.3

键盘的驱动，c代码，给嵌入式用的，可以拿来自己研究用，比较不错。大家多交流-Keyboard driver, c code for embedded use, and can use their own research, a good comparison. Members will exchange

FX2开发板程序下载C -FX2 development board downloads C

电机测速源码程序，好使的已经通过测试了。非常精确-Motor Speed-source program, so that has passed the test. Very precise

这是Beagle_Allegro_B 板子的PCB图，供大家画图时参考使用-This is the PCB board Beagle_Allegro_B map, drawing reference to use for everyone

基于单片机8051的嵌入式开发指南.pdf 电子工业出版社-Based on the 8051 single-chip embedded development guide. Pdf Publishing House of Electronics Industry

这是一个就算波特率的软件，功能强大，在单片机通信时不用自己动手计算，只要用此软件点击一下，就能得到结果。-This is a software that even if the baud rate, powerful, in the MCU communicate without it-yourself basis, as long as the click with this software, you can get results.

Source code for micro printer driver

功能：利用时钟芯片DS12887在LCD（LCM141）上显示时间，通过4×4键盘来修改时间，利用MAXIM232进行标准串口发送。4×4键盘中有数字键（0～9）和功能键（F1键为“→”，F2键为“←”，F4键为“发送”，设置键为“设置当前时间”，确定键为“把修改的当前时间写入到DS12887相应的存储单元中”）。 硬件：单片机为8K的98C52（ATMEL），LCD为北京青云的LCM141，标准串口总线为MAXIM的232芯片，时钟芯片为DS12887（DALLAS） -Function: the use of clock chip DS12887 in the LCD (LCM141) show time, through the 4 × 4 keyboard to modify the time and using the standard serial port to send MAXIM232. 4 × 4 keyboard in numeric keypad (0 ~ 9) and the function keys (F1 key for the