用单片机实现的单片机语言测试的C++语言

本文详细系统地介绍了uC/OS-II 在51 单片机上的移植、重入实现方法、硬件仿真、固化、人机界面等关键内容。-paper detailed and systematic introduction of the Phone/OS-II in 51 MCU transplant and re-entry method, hardware simulation, curing, the man-machine interface and other key elements.

单片机AT90S系列 制作简易USB接口（软件模拟,无usb硬件）。 programmer- Monolithic integrated circuit AT90S series manufacture simple USB connection (software simulation, non- usb hardware). Programmer

基于单片机的无线遥控系统，这是本人精心制作的课程设计，花了将近一个月的时间才完成的。里边有具体的程序代码，全都是仿真通过，并且做出了pcb板，经得起考验的-Based on single-chip wireless remote control system, This is my elaborate curriculum design, has spent nearly a month before the finish. Inside there is a specific code, all the simulation are passed, and made a pcb board, stand the test of

电机不转，按下启动键，电机旋转，速度为25转/分，按下加1 键，速度增加，按下减1 键，速度降低，最高速度为100 转/分，最低转带为25 转/分，按下停止键，电机停转。速度值要求在数码管上显示出来。-Motor does not turn, press the start button, motor rotation speed of 25 rev/min, press the 1 key, the speed increase by 1 press the button to lower the speed, the maximum speed of 100 r/min, with a minimum of 25 to r/min, press the stop button to stop motor. Speed value of the requirements in the digital tube display.

需要凌阳的IDE打开，是c和汇编的综合，学习凌阳16位单片机的基础题目-need Sunplus IDE open, and c is a comprehensive compilation, learning Sunplus 16 topics based MCU

一个用于驱动TFT屏的驱动程序,使用IC:1828,program (无EEPROM 无IR,完整说明)IIC只写一个-driving a TFT screen for the driver, the use of IC : 1828. program (no EEPROM non-IR, a complete explanation) just write a IIC

LCD应用显示keil编写非常实用的C程序-LCD display keil prepared very practical application of C-program

此为AD9850的驱动程序,经过实验,发现可行-This is the AD9850 driver, after the experiment and found that viable

已经调试成功的程序，在CVAVR中实现的。-Debugging process has been successful in achieving the CVAVR.

用C来实现实时时钟。对比与上个汇编语言。-Using C to achieve real-time clock.