DCT的汇编实现

TI DM648 TIMER配置源代码,可以下接下到板子上,非常不错-TI DM648 TIMER configuration source code, can be the next to take over the board, very good

TMS320DM6446平台下，烧写NAND FLASH 的程序，使用方便。-TMS320DM6446 platform, the programmer NAND FLASH procedures and easy to use.

mpeg2_loopback为MPEG2算法的DEMO，主要是将每一帧的图像编码，然后解码输出。-mpeg2_loopback for MPEG2 algorithm DEMO, mainly to each frame of image coding, and then decode the output.

adsp2116x的向量乘运算-adsp2116x vector multiplication

TI公司的视频处理器DM642的开发板EVM642的测试程序，对调试硬件和编写程序的参考价值极大。-TI

bf533平台对于SD、MMC卡读写的底层驱动。-bf533 platform for SD, MMC card reading and writing low-level driver

TMS320C54X DSP 实验指导程序 实验一 常用指令实验 实验二 数据存储实验 实验三 I/O实验 实验四 定时器实验 实验五 INT2中断实验 实验六 A/D转换实验 实验七 D/A转换实验 实验八 AD/DA综合实验 -TMS320C54X DSP experimental procedures to guide an experimental common directive experimental experimental data storage is 2 three experimental testing of I/O The Experiment The Experiment 4 timer interruption five INT2 The Experiment 6 A/D converter The Experiment 7 D/A conversion The Experiment 8 AD/DA Experiment

dsp 2407的三相逆变器汇编源程序 -dsp 2407 compilation of the three-phase inverter source

按频率抽取计算FFT的C++源代码，可以较方便地移植到有C/C++开发环境的DSP中去-by FFT frequency calculated from the C source code, can be easily ported to the C/C development environment to the DSP

在C54X DSP下写的串口收发程序，利用串口收发数据,并在DSP内对数据作简单处理!-under the C54X DSP serial port transceiver written procedures, the use of serial data transceiver, and the DSP within the data processing simple!