evmdm6437 _ nandflash

硬件要求：基于合纵达的SEED-VPM642的示例。软件要求：CCS2.2以上版本。对于想用DSP/BIOS开发的同道中人来说是很好的学习实例。-Hardware Requirements: Based on the combined vertical up the SEED-VPM642 example. Software Requirements: CCS2.2 above. For want to use DSP/BIOS development for the fellow human is a very good learning examples.

mp2解压程序 -Decoder of mp2

这是我编的矩阵相乘的dsp程序,可调整矩阵维数,汇编语言编程,执行效率高,工程文件全,打开就可以使用.在TI的ccs上调试成功,用的同样是54系列的dsp.-This is my series of matrices of dsp procedures, adjustable matrix dimension, assembly language programming, the implementation of high efficiency, the whole project file, open you can use. In TI

TMS320LF2407A构成的EEPROM读写程序AT24C02.rar-TMS320LF2407A posed EEPROM read and write procedures AT24C02.rar

一个用dsp实现简单语句输出处理的程序，在ccs上运行。-Realize a simple statement with dsp output deal with the procedures to run in the ccs.

这是测试SEED-VPM642硬盘接口的程序。-This is a test SEED-VPM642 hard disk interface procedures.

DM6446中串口的学习代码，有利于学习其中的使用方法-DM6446 in learning serial code, which is conducive to learning to use

基于DSP网络中的TCP/IP协议研究，本文通过对TCP/IP协议的具体分析,解决了以数字信号处理器(DSP)为核心的局域网络DSP端的IP地址问题,实现了DSP与PC机之间的UDP协议通信-DSP-based network TCP/IP protocol, the paper through the TCP/IP protocol specific analysis to solve a digital signal processor (DSP) as the core DSP LAN side IP address problem, the realization of the DSP and PC machine UDP protocol communication between

128点FFT滤波的程序，可以直接用于TMS320F2812中。需要在CCS2.2下进行开发-128-point FFT filtering procedure can be used directly in TMS320F2812. Need to be developed under the CCS2.2

永磁同步电机矢量控制程序，TMS320LF2407上运行，汇编代码-PMSM vector control procedures, TMS320LF2407 run, compile code