c51单片机与ＰＣ间的串口 通信驱动程序

3线双向零等待IO通讯机制 单片机通讯源代码带说明-3 bidirectional zero waited for the IO communication machine-made monolithic integrated circuit communication source code belt explained

本程序功能是利用单片机控制用户板上的小键盘，将按下的键通过单片机的串口发送给PC机，在PC机串口助手显示出来。用行翻转法的方法来识别输入的键盘。 二、通过单片机将键盘按下的键在LCD上显示出来。 -This procedure is the use of single-chip control functions of the user on-board a small keyboard, the keys will be pressed through the single-chip serial port sent to the PC, the PC Serial Port assistants displayed. Line inversion method used to identify the method of keyboard input. Second, through the single-chip microcomputer keyboard keys pressed on the LCD display.

LT_1B msp430开发板例子程序－TA_6

T6963C驱动 调入了一幅图象: 长度x宽度=240x128, 调整后为: 240x128-T6963C drives a transferred image: length x width = 240x128, adjusted for: 240x128

单片机和电脑串口通讯，这个是电脑向单片机发送数据。-Single-chip and computer serial communications, this is a single-chip computer to send data.

测试GPIF用的原理图、上位机程序，以及固件-GPIF test used schematics, PC procedures, as well as firmware

通讯误码仪测试软件-communications software error Test

这个是多机通信的程序，虽然老了点，但是用与实验是很好用的，本人昨天刚去试过啊，呵呵，希望对大家有帮助，嘿嘿 -This a multi-machine communication procedures, although old, but with the experimental use is a good use, and yesterday I just tried to ah, what we want to help, laughter

SD卡读写程序 1. sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. 2. SD目录: SD卡读写模块的全部文件,一般不用修改. 3. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改, 而sdconfig.h通常会有改动.-1. Sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. 2. SD directory: SD card reader module of all the documents, the general need not be amended. 3. Proposed sdconfig. h files directory should not be put in SD because SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

ds时钟芯片编程 对ds时钟芯片进行设置时间，读取时间等的操作-ds clock chip programming right ds clock chip for set-up time and the time to read the operation