C51 microcontroller introduce Chinese

keil C51 L―Test事例-L-Test case

异步串行通信接受单元的设计源程序 异步串行通信接受单元的设计源程序-Asynchronous serial communication module designed to accept source asynchronous serial communication module designed to accept source code

keil-c51单片机的学习宝典，经典中的经典啊！-keil-c51 MCU learning canon classical ah!

采用C51编写的基于C8051F020单片机的定时器实用程序。-using C51 prepared by the C8051F020 timers utility.

电子定时器的设计 有程序的具体实现和功能描述 好的程序-electronic timer with the design of specific procedures to achieve good functional description and procedures

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

用LPC2132驱动SPI接口FLASH的c驱动程序，调试完全通过-SPI interface with LPC2132 Driver FLASH

用PIC单片机的I2C接口读写片外EEPROM(AT24C08,也可以直接用到AT24C01/02/04/16)-PIC microcontroller with the I2C interface writable EEPROM chip (AT24C08. can be used directly AT24C01/02/04/16)

NRF2401_send2 c8051f330 无线接收程序-NRF2401_send2

一个单片机心电图数据采集带通滤波的算法。-ECG data acquisition of a single-chip band-pass filtering algorithms.