I have made a transmission on the RS232 applet, you can transmit data, please ad...

moden串口编程（涉及AT指令，通用异步接收发器UART）-moden Serial Programming (involving AT command universal asynchronous receiver transmitters UART)

多线程串口通信的例子,可以实现同时多串口的通信-multithread serial communication example, can achieve more while the Serial Communications

chch串口程序-ch ch Serial procedures

一个简单的，完成SerialPort的连接测试 对引导初学者进入更高层次-a easy serial port

一个Mega8 SPI读写DataFlash的代码,是用C语言编写的。可访问Atmel AT45Dxxx dataflash，支持512Kbit - 64Mbit。 -a Mega8 SPI DataFlash code reader, is to use the C language. Visit Atmel AT45Dxxx dataflash, support casing- 64Mbit.

16550串口代码-serial code 16550

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

basic driver for RS232

一个很好用的comm类，对于开发串口工作很有帮助，因多次测试没问题！可在98/2000/xp上正常使用-a good use of comm category, serial work for the development of useful, because several tests No problem! In normal use 98/2000/XP

VB通过串口控制单片机读写24C02源代码-VB to read and write through the 24C02 single-chip serial port to control the source code