LED 发送字模系统

串口通信自动检测程序，已经通过测试，能够成功在2812板上运行。-Automatic detection of serial communication program, has passed the test, be able to successfully run on the board at 2812.

getmywish使用的usb注意：由于用到多串口控制，需要在收到数据时确定是哪个串口来的数据。 下面是串口事件处理函数代码： -getmywish use usb Note : As used Multiport Serial control, the receipt of necessary data to determine which of the serial data. Below are the serial code incident handling functions :

一本介绍串口通信不错的书-introduced a serial communication good book

f2812串口通信接口B口，c语言,中断-f2812 serial communication interface B port, c language, interruption of

W77E58双串口通信源代码 注：此源程序只作参考，内有些函数未有原型，借鉴在于其通信方式及其设置。 CRC检校可另参考其它代码。 -W77E58 dual serial communication source code Note : This program is for reference only, not some function prototype experiences in his means of communication and set up. CRC calibration can be a reference to other codes.

串口编程代码 使用spcomm的 有例子事例-serial programming code used spcomm examples of instances

PIC的编程程序范例，分析的比较清晰，能够供初学者学习-programming PIC procedure example, the analysis is relatively clear, for beginners to learn

在此以串口驱动程序中初始化过程为线索简单讲一讲WindowsCE下驱动程序开发基础-this in the serial driver for initialization process as simple as talking about the clues driver under Windows CE Sequence development foundation

利用西门子的GSM芯片（TC35）的手机模块实现短信的读写，该手机模块可以加入SIM卡，然后就跟手机一样使用了，程序可以通过串口进行控制-The programme use GSM CMOS chip(TC35) module to read and write short message, you can insert SIM card into this module, then it can work as ordinary Mobile phone,the programme can control the module through com port.

用 VB 写的对云台进行控制，主要用于监控系统的云台控制-VB wrote to the pan-tilt control, mainly for the Monitoring System Console Control