实现了一个16550 / 16750 UART核

使用TC3.0开发的串口通讯程序，在一台电脑上模拟。（本机发到串口，本机再从串口读入）-TC3.0 development of the use of serial communication program, in a computer simulation. (This machine made to the serial port, the company was again read from the serial port)

Philips的LPC900系列，串口配置事例-Philips series, serial configuration examples

使用说明： 系统要求：WIN9X/ME/NT/2000 VC++6.0 且安装了VC ACTIVEX控件（在VC6安装时选上） 免费 简介：在VC++6.0中用MSComm控件编程，可以实现串口接收数据和发送数据，数据分别显示在接收框和发送框中。-Usage: System Requirements: WIN9X/ME/NT/2000 VC++ 6.0 and installed VC ACTIVEX controls (in VC6 installation selected) Free Introduction: In VC++ 6.0 using MSComm control programming can be achieved Serial receive data and send data, data were displayed on the receiver box and sent box.

check if COmPort is Available

Virtex2的网卡接口程序，使用C语言编写。-Virtex2 the connector, the use of C language.

电子警察拍照管理系统，简单易用，源码开放，可以自己扩充方便。-electronic management system, easy to use, open source can facilitate their expansion.

plc中基于数据采集、发送接收、驱动、写入数据库-plc-based data acquisition, send to receive, drive, write to the database

GPS数据采集程序 希望对各位有用-GPS data collection procedures hope useful to you!

一个简单的电脑红外遥控驱动程序，只能识别特定的红外信号（我是基于K11B遥控器编的），不能自动识别，还有一些简单的，控制其它程序的方法-A simple computer infrared remote control driver, could only identify a specific infrared signals (I was compiled based on the remote control K11B), does not automatically recognize, there are some simple method of controlling other programs

注释 用VC++编写USB接口通信程序 -prepared USB Communication Program prepared by VC USB Communication Program