这是很全的标准库啊，不是1164.vhd，都是一些加，乘，除，平方等操作的包来的．...

这是使用systemgenerator的一个入门程序和范例使用matlab和system generator共同实现，并配有教学文档，清晰简单，易懂(This is an entry using systemgenerator procedures and examples using matlab and the system generator together to achieve, and with a teaching document, clear and simple and easy to understand)

THE IMPLENTATION OF THE MAC PROTOCOL USING THE FPGA ALTERA 3

VGA显示原理与VGA时序实现论文,详细介绍了VGA的原理 (Principle and VGA VGA display timing to achieve paper, detailing the principles VGA)

在FPGA开发板显示字符串,采用VHDL语言,以简单的功能说明FPGA的开发流程.-In the FPGA development board shows the string, using VHDL language, in a simple functional description FPGA-development process.

crc-16的编码，使用的多项式是G(x)=x^16+x^12+x^5+1(generator polynomial of degree 16: G(X)=x^16+x^12+x^5+1)

08EE06EDA 实验 4（VHDL 状态机设计_序列检测器）6/7/2008-design thesis requirement by vhdl

曼彻斯特编码技术用电压的变化表示0和1。规定在每个码元中间发生跳变。高→ 低的跳变表示0，低→ 高的跳变表示为1。每个码元中间都要发生跳变，接收端可将此变化提取出来作为同步信号，使接收端的时钟与发送设备的时钟保持一致-Manchester coding techniques that use voltage changes in 0 and 1. Provisions in the middle of each symbol hopping happen. High → low hopping express 0, low → high jump for the express one. Symbol between each transition must happen, this change in the receiver can be extracted as a synchronization signal to the receiving end of the clock and send the equipment to maintain the same clock

This a verilog file which is used as a decoder-This is a verilog file which is used as a decoder

LAB 9, Excercise for DE2 Altera

very good code for edge detection based on vhdl programming.