基于AVR单片机ATmega32 DS1820的驱动程序

8路AD采集系统，数字电压表，采用ADC0809模数转换芯片，单片机控制的数字采集系统-8-channel AD acquisition systems, digital voltage meter, the ADC0809 analog-to-digital converter chip, single-chip microcomputer controlled data acquisition system

系统按键显示都具有,不同的I/O口,具有很大的参考价值-System button shows have different I/O port, and it is very useful

两个点的线性插值定点数算法 说明：1、基本公式 y=( y2-y1 ) ( x-x1 ) / ( x2-x1 ) + y1 2、根据直线斜率的正负、内插外插的不同，分为6种情况。 3.参见文件夹中的“插值算法的6种情况”一图。-two points of linear interpolation algorithm for determining points : one, the basic formula y = (y2- y1) (x-x)/(x2- x1) y1 2, according to the slope of the linear positive and negative, interpolation, extrapolation of different, divided into six kinds of situations. 3. See folder "interpolation algorithm for the six species of" a map.

用于串口数据的监视，对于想要通过串口开发程序的朋友一定很有帮助。-Serial data for surveillance, for want through the serial development process will certainly be helpful friend.

Program for ADC0808 with 4 bit LCD routine. It also includes Protus Debug file.

嵌入式控制器硬件电路设计。里面有介绍各种嵌入式控制器，及其电路设计和软件实现-Embedded controller hardware design. Which have introduced a variety of embedded controllers, and circuit design and software implementation

C8051F350单片机24位AD采样程序。-C8051F350 single-chip 24-bit AD sampling procedures.

16*16点阵的，觉得这个里面用 指针来查找数组蛮好的 。-16* 16 lattice, and find this inside with fine pointer to the search array.

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention