液晶显示模块与单片机接口技术

这是一个采用avr单片机操作显示sst1815液晶模块的程序，调试同过。sst1815采用的是仿真总线方式工作，8080协议。-This is an operation using SCM avr sst1815 LCD display module, Debugging with Guo. Sst1815 using the simulation methods Bus, 8080 agreement.

基于51系列的电子锁设计方案，包含程序，pdf文件-Based on the 51 series of electronic lock design options, including procedures, pdf file

这是一个基于89C51单片机的简易信号发生器的源程序，程序代码由C语言编写-This is an 89C51 microcontroller based on the simplicity of the source signal generator, code written in C

利用AT89C51单片机做的一个音乐卡,可以播放多首歌曲-AT89C51 single-chip microcomputer use to do a music card, can play more songs

本程序实现通过BDM方式访问MOTOROLA 9S12单片机EEPROM，可自动配置波特率，包含读、写、擦除三种功能。-This procedure, through BDM realize MOTOROLA 9S12 Singlechip access EEPROM, can automatically configure the baud rate, including reading, writing, erasing three functions.

步进电机正反转及调速控制--51单片机学习--c语言的-Positive inversion and Speed Control Stepper Motor

单片机课程设计的LCD显示，附带有程序，仿真图，以及原理。-LCD display, there are procedures, simulation plans, as well as the principle of

FlashFlex51微控制器

ST736单片机，驱动液晶芯片HT1623-ST736 MCU, LCD driver chip HT1623

AVR309-USB 到 UART 协议转换程序。-AVR309-USB to UART protocol conversion process