STC单片机IO口模拟RS232测试程序,Keil Cx51应用开发技术中的程序主要的功能是在利用串口调试工具发送一个8bit的数据，而后单片机接收后把这个数据...

这是LCD1602与msp430之间的通信,其实可以直接从51移植过来,但是一定要在硬件加上拉电阻,要不然是不通不过的,我说的是你用的是5V的LCD-This is the LCD1602 and communication between the MSP430 can in fact be a direct transplant from the 51, but must be coupled with pull-up resistor in the hardware, otherwise it is unreasonable, however, I say is that you use the LCD is 5V

红外线遥控器按键检测程序. 通过检测两次下降沿之间的时间差判断接受到的数据位. 已经通过了测试,能够正确区分出32bit数据的遥控器按键键值. 具有数据重发功能,但是数据的重发有点频繁. 使用晶震频率为11.0592MHz,所有定时值都是基于这个频率计算. 占用很少量的CPU时间,使用了外部中断0接受数据,定时器0进行计数, 定时器1作为串口的波特率发生器(Band = 9600).-Infra-red remote control button detection program. By detecting falling edge twice to determine the time difference between the received data bit. Has passed the test, could correctly distinguish 32bit data button remote control key. With data re-issued, but data a bit of re-issued frequent. Zhenyuan frequency of use of crystal 11.0592MHz, all timing values are calculated based on this frequency. occupied by small quantities of CPU time, use the external interrupt 0 to accept data, timer 0 to count, timer 1 as a string port baud rate generator (Band = 9600).

DMA例程，51单片机读写DMA的C语言程序和汇编程序-DMA routines, 51 single-chip DMA read and write C-language programming and assembler

CC2430 基础实验十 片内温度的实验-CC2430 10 experiments based on the experimental temperature

此程序可以实现两个单片机之间的相互通信；串口采用方式1工作，10位异步接受和发送，波特率可变，由定时器1控制；且含有校验-This program can be achieved between the two microcontrollers communicate with each other serial port mode 1 using the work of 10-bit asynchronous receive and send, variable baud rate, from Timer 1 control and contains a checksum

这是一个CAN总线通信的节点程序，是我自己编写的，希望指正。-This is a CAN bus communication nodes procedures, the preparation of my own, and I hope correct me.

基于凌阳单片机的 语音自动播放音乐汇编程序-Sunplus based on single-chip voice automatically play music compilation procedures

Discription: This multi-master driver provides the software interface to the I2C Bus hardware of the M3062x series of MitsubishiMCU.

51单片机浮点数存放到EEPROM中的程序范例-51 microcontroller to float stored in the EEPROM process model

液晶资料大全，下了看看吧。-LCD information Daquan, with a look at it.