这是一个关于秒表倒计时的程序，写的很经典，拿来就可以用...

这个做了一个可以随着曲线而移动得小球，很好玩，大家看看是怎么随曲线移动得-This can make a curve and move with a small ball, is a lot of fun, let us look at how the Mobile curve with a

网上虽有有大量的LCD驱动源码，但符合自己使用的不多，次篇非我原作，但经过我修改。-online although a large number of LCD driver source code, but in line with its own use of small, sub-dividing the world the original articles, but I have to amend.

LPC2103,蜂鸣气编译程序，很好用，IAR环境下-LPC2103, beep gas compiler, very good use, IAR environment

用89C2051实现高精度Sigma-Delta ADC变化-89C2051 realize with high precision Sigma-Delta ADC changes

通用的餐饮收费系统:其主要技术是通过计算机串口与IC卡相关设备进行数据交互.-Common food and beverage charges system: Its main technology is the computer serial port and IC card relevant equipment data exchange.

利用89C2051实现模数转换的一种方法源程序，该程序使用C51语言编写，可以用于MCS8051单片机-use 89C2051 analog-digital conversion of a way to the source, the procedure used to prepare C51, SCM can be used Mcs8051

利用LABview做的解无线传感器节点的包的数据的程序-Does the solution make use of Labview wireless sensor nodes process data packets

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

采用IAR在线调试ADI基于ARM7内核的ADUC7026的RAM_CODE-IAR debug using online ADI based on ARM7 core ADUC7026 the RAM_CODE