VGA显示程序，显示生日快乐

ADDER USING VERILOG ADDER WITH VERILOG VERILOG ADDER

1K SRAM，安排字的32位，独立的读写端口，ASIC设计Verilog代码 采用偶校验对1的计数。 还带有测试平台

1、PC和寄存器组使用时钟触发。 2、指令存储器和数据存储器存储单元宽度一律使用8位，即一个字节的存储单位。 3、控制器部分可以考虑用控制信号真值表方法（有共性部分）与用case语句方法逐个产生各指令其它控制信号相配合，注意：信号必须与状态配合。。当然，还可以用其它方法，自己考虑。 4、试用的汇编程序，而且必须包含所要求的所有指令。Slt、sltu指令必须检查两种情况：“小于”和“大于等于”；beq、bne指令必须检查两种情况：“等”和“不等”。这段汇编程序必须尽量优化，同时，给出每条指令在内存中的地址。(1, PC and register groups are clocked. 2, the command memory and data memory storage unit width will use 8 bits, that is, a byte storage unit. 3, the controller part can be considered with the control signal truth table method (common part) and with the case statement method to produce each command other control signal match, Note: the signal must be with the state. The Of course, you can also use other methods to consider their own. 4, try the assembler, and must contain all the required instructions. Slt, sltu instruction must check two cases: "less than" and "greater than or equal to"; beq, bne instruction must check two cases: "wait" and "unequal". This assembler must be optimized as much as possible, giving the address of each instruction in memory.)

说明：  小波变换的开源代码（Verilog HDL）包括有测试文件，本人看过，挺好。(code of dwt)

8位突发长度，一次64bit数据读写，MIG核(DDR3 controll implimention)

自己写的位同步实验程序参考，该算法需要发送和接收方的频率比较稳定时，可以很快地达到位同步，且十分稳定。位同步是通信技术的基础之一，希望对大家学习有所帮助。(The program is a reference used for bitsynchro writed by myself.When the both send s and receive s frequency are stable,the program can reach bitsynchro fastly.)

verilog 简易频率计的设置，包括整个工程(verilog simple frequency meter settings, including the entire project)

利用verilog驱动LCD1602 本实验是用LCD1602显示英文。（LCD带字库）(//Use verilog driver LCD1602// video tutorial for all of us 21EDA e-learning board// The experiment is LCD1602 display in English. (LCD with font))

thesis about design and implementation neural network using FPGA

使用metlab生产正弦波和三角波的采样值，供vhdl等语言调用来产生波形(use metlab production sine wave and triangular wave of sampling, for languages such as call vhdl to generate waveforms)