AT45db021的模拟总线驱动程序。具有很详细的说明。绝对好用。...

用凌阳单片机控制显示电压步进，增减，并输出模拟电压

ＡＤＣ０８０４程序设计是和ＡＤＣ０８０８相似-ADC0804 and ADC0808 program design is similar to

TM160 OCCWUGWA1 and uc1698资料和驱动程序-TM160160OCCWUGWA1 and uc1698 Driver

能够掌握单片机的管脚功能，简单了解并应用单片机作东西。-to grasp the pin MCU functions, simple to understand and use things for the MCU.

由ADC0809的IN0输入一模拟电压，经过A/D转换后，在三位数码管上显示转换后的数字量-IN0 input from one of the ADC0809 analog voltage, after A/D conversion, in the three digital tube display digital converted

利用单片机产生pmw，控制led，修改后可控制直流电机-Single-chip computer generated pmw, control led, modifications can be controlled DC motor

这是参加电子设计大赛时的作品：红外遥控小车：用红外线通过一块AT89S52单片机发射信号即编码，并用红外接收头接收信号；接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码，最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯，而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.

电子点阵显示器（8*8）.-。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。。

模拟串口实现代码, Baud: 9600Bps , Format: 1,8,1,无校验位, MCU:M88 , CRYSTAL:3.6864M , ICC AVR6.31A , 占用定时器T0(工作在查询方式) ,在项目中使用,收发一切正常.-Simulation of serial code, Baud: 9600Bps, Format: 1,8,1, no parity bit, MCU: M88, CRYSTAL: 3.6864M, ICC AVR6.31A, occupation timer T0 (in query mode), in the project use, send and receive all normal.

altera de1开发板 dma,pwm...实验源码-altera de1 development board dma, pwm ... experimental source