good software. You must look at the ah? My classmates with him!

AT89S51 红外程序 单片机学习板的程序 外部中断0程序-Procedures for single-chip AT89S51 infrared study of the process board procedures external interrupt 0

tlc1543AD转换程序,TLC1543 AD采样子程序-tlc1543AD the conversion process, TLC1543 AD sampling subroutine

键盘控制页面显示。屏蔽一些键盘事件。F1.F2.F3控制不同显示模式。-jianpan

AVR简单的串口程序，适合初学者学习，可以直接应用-AVR simple serial program, suitable for beginners to learn, can be applied directly

采用单片机控制的cs8900芯片的驱动和TCPIP协议栈-using micro-controller chip the cs8900 drive and TCPIP stack

用C语言编写的对时钟芯片ds1302读写的单片机程序，内附详细的注释说明。-Using C language to read and write to the DS1302 clock chip microcontroller procedures, containing detailed notes.

此程序为单片机开发过程中定时芯片ds1302的控制并用lcd显示的程序，用汇编语言编写。供参考用-procedure for microcontroller development process of regular chips ds1302 control and LCD display with the procedures in assembler language. For information

本设计以P89V51RD2FN单片机为电动小车的控制核心，采用MSA-LD2.0倾角传感器实时测量跷跷板的倾斜角，用ST198光电传感器检测黑色引导线监测小车运动。光电传感器和倾角传感器模块把实时测量信号馈送至单片机，利用专用细分芯片TA8435H驱动步进电机，以脉宽调制式斩波方式对步进电机步进角进行细分，控制和调节小车速度。采用增量式PID控制算法确保小车能够达到平衡；用RT128×64M液晶显示时间、角度等参数。经测试表明：小车各项性能指标达到设计要求，能够实现30秒内小车行驶到规定点，并保持跷跷板平衡；在跷跷板一端配重可调整的情况下，小车也能自动找到平衡点并保持跷跷板平衡。-The single-chip design for the electric car P89V51RD2FN control of the core, the MSA-LD2.0 seesaw angle sensor real-time measurement of the tilt angle, the detection of black ST198 photoelectric sensor to monitor vehicle movement and guide lines.Photoelectric sensors and angle sensors in real-time measurement module to feed the signal to the microcontroller, using a dedicated sub-chip stepper motor driver TA8435H to PWM chopper-type stepper motor on the sub-stepping angle, control and regulation vehicle speed. The use of incremental PID control algorithm to ensure that the car can achieve balance with LCD RT128 × 64M time, angle and other parameters.After the test showed that: the performance car

单片机直接驱动液晶模块, 可以值得大家参考一下-MCU directly drive LCD module may be worthwhile for your reference

数码管的显示子程序，对于用PROTEUS来仿真的同志，可以尝试的玩一下-Digital tube display subroutine for simulation using PROTEUS to comrades, you can try to play like