Learn hands

8*8键盘检测，我用keilc进行开发的-8* 8 keyboard detection, I used to carry out the development of keilc

单片机实现直流数控稳压电源,可调电压为0-9.9伏,步进为0.1伏,可以自动扫描键盘以增加或者减少电压-MCU NC Regulators DC power supply with adjustable voltage of 0-9.9 volts, stepping to 0.1 volts, can automatically scan the keyboard to increase or reduce the voltage

我自己做的给予ST公司的upsd3234a单片机的频率计。可以测量10K以下的频率。这是此频率计的自检程序，在KEIL上调试仿真通过。-I have to do to give the ST

Pic18F458的Can通信模块代码 -Can communication module of PIC18F458 code

金鹏LCD驱动，单片机和液晶的底层接口程序。可以在液晶的任意位置显示任意字符（包括汉字、字幕和ASCII图形）、字符串-Jinpeng LCD drivers, MCU and the bottom of the LCD interface program. Can be anywhere in the liquid crystal display of arbitrary characters (including Chinese characters, titles, and ASCII graphics), string

美国TI公司的protel 元器件库，在应用中需要更新，本人收集了最新的版本共30M，为提高上传速度分六次上传。文件名依次为TI_1到TI_6。希望大家设计电路板时少走弯路这里是第二个TI-2-TI" s U.S. Treasury protel components, need to be updated in the application, I collected a total of up-to-date version of 30M, to improve the upload speed upload six hours. File name followed by TI_1 to TI_6. Hope that the design of circuit board less detours here is the second TI-2

单片机对SJA1000的驱动，包括初始化，收发数据，中断- MCU drive for SJA1000(include initial,transmit and receive data,interruption and so on)

利用单片机演奏音乐的程序-SCM procedures performed music

单片机是52的，P0口连到四个数码管的七个管脚，其中两个冒号点为最后两个数码管的DOP点，P1.0至P1.3为四个数码管的选通端，低电平有效。程序2较完整，可实现设定时间功能。-Singlechip is 52, P0 port connected to four of the seven-pin digital tube, two of which point to the last two colon tube DOP-point digital, P1.0 to P1.3 for the election of four digital tube pass-side, active-low. 2 a more complete procedure, set the time function can be realized.

TS-1620原理图和程序 TS-1620原理图和程序-TS-1620 schematic diagram and procedures for TS-1620 schematic diagram and procedures