Keilc51和proteus环境下实现的0－50MHz的频率计。

CAN的51单片机源程序 ARM经典 C语言写的-CAN 51 single-chip ARM classic C language source code written in

单片机实验，实现双字节无符号数的加法，利用查表指令，在此基础上可以学习查表指令的用法-SCM experiment, to achieve double-byte unsigned number of addition, using look-up table instructions, on this basis, can learn the usage of table look-up instruction

是液晶显示屏的驱动程序，很好的啊-LCD display driver, very good ah

本设计采用凌阳16 位单片机SPCE061A对步00进电机进行控制，通过IO口输出的具有时序的方波作为步进电机的控制信号，信号经过芯片L298N驱动步进电机；-This design uses 16-bit single-chip Sunplus SPCE061A to step into the motor control 00, through the IO port with the output timing of the square wave as a stepper motor control signal, the signal after the chip stepper motor driver L298N

TLC5618 D/A 输出-Programmable DoubleChannel12-bit DACTLC5618in D/A output

SN75176,用51系列的单片机，波特率为9600，串口方式1，发送数据-SN75176

pt2272与2262完全仿真程序，并可以搜索全0到全1的地址码和各种振荡电阻-pt2272 with the 2262 full simulation program, and can search the entire 0 to the whole of one address code and a variety of oscillation resistor

温度传感器 DB18B20 单片机89c51-dddjanadadadszdaxca

主要功能是实现16*16LED阵列的汉子显示，程序简单易懂，适合刚刚接触单片机和c语言的学者-Main function is to achieve 16* 16LED array guy show, the program simple and easy to understand, for just contact with scholars of microcontroller and c language

音乐兰花草播放演示，汇编编写，用的是扬声器，不是蜂鸣器!-Music orchids player demo, compilation of writing, using a speaker, not the buzzer!