单片机C语言入门_对刚接触嵌入式开发的人员很有好处

AT45DB021B的C51驱动程序-AT45DB021B driver of the C51

firmware 3.3.4.8 for int6000 powerline

用PIC单片机写得HT1621驱动程序!-PIC microcontroller written HT1621 Driver!

入式2410开发板-income-2410 development board

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

一个使用C51编写的视频切换器的控制程序，用于16选4的视频切换-use C51 to prepare a video switcher control procedures for the April 16 elections Video Switch

单片机c语言教程 呵呵 早就下的了 不错了-SCM c language tutorial He He already has pretty good under the

本程序是基于89C51的足球换人牌的功能实现-This procedure is based on the 89C51 football Substitution realization of the function card

这个程序是用MSP430写的chipcon公司的无线收发芯片CC1100的驱动程序。-This procedure is written MSP430 Chipcon

MSP430 开发例程-MSP430 development routines