s24193 液晶ARM，8051驱动程序！

用于网络馈电的c51程序-network feed for the decoder procedures

电机控制的程序例程，方便大家在座相应的工作中应用-Motor control routine procedure to facilitate the work of everyone here the application of the corresponding

这是一篇关于嵌入式系统的LCD液晶驱动程序的资料及源程序-This is an embedded system on the LCD driver and source of information

飞思卡尔智能车 开环设计 大家不妨借鉴一下。-Freescale open-loop design of the smart car you may wish to learn from you.

nRF24L01 RF接收发送例子程序，采用C语言-nRF24L01 RF receiver to send examples of procedures, the use of C language

单片机的内部定时器应用-SCM internal timer Application

采用C语言开发的16位单片机dsPIC，应用于飞行控制，此段为计算偏距的PID算法-Using C language development of 16 single-chip dsPIC, applies to flight control, this paragraph the purpose of calculating the offset of the PID algorithm

根据公版自己做的usbasp板，添加了usbcdc。-According to the public version of their own to do usbasp board, added usbcdc.

基于61202控制芯片的LCD液晶显示驱动程序。-LCD controller chip LCD driver.

网线测试仪程序，可测试网线长度（300M内），排序，用脉冲反波测试，时间*速度=距离的原理。-Cable tester program to test cable length (300M) with sorting, using anti-wave test pulse, time* speed = distance principle.