C8051Fxxx单片机的C语言例程，所有外围设备和我们所有的希望。

atmel公司atmega单片机bootloader的源代码-ATmega Atmel single-chip companies bootloader source code

一个非常好的单片机读写液晶的程序，已经服了源码。-A very good single-chip LCD to read and write procedures, had already served a source.

完整的实现RS232与TCP/IP网络协议的转换-Realize the full RS232 and TCP/IP network protocol conversion

SST25LF020A存储器SPI驱动程序-SST25LF020A memory SPI Driver

msp430驱动12864液晶 串行模式-msp430 driver 12864 LCD serial mode

CAN的调试程序。CAN的初始化重要包括下面几个方面。RXB0SIDH，RXB0SIDL，RXB0MIDH，RXB0MIDL。这是接收过滤器。TXB0SIDH，TXB0SIDL，TXB0DLC，这是发送标志位。还有波特率寄存器。操作模式为 正常模式。-CAN debugging procedures. CAN initialization important aspects include the following. RXB0SIDH, RXB0SIDL, RXB0MIDH, RXB0MIDL. This is the receiver filters. TXB0SIDH, TXB0SIDL, TXB0DLC, it is sending signs spaces. There baud rate register. The normal mode of operation for the model.

一个电容计的51源代码，我自己参加电子设计大赛使用的。-a capacitance of 51 source code, I participate in the electronic design competition to use.

我自己做的给予ST公司的upsd3234a单片机的频率计。可以测量10K以下的频率。这是此频率计的自检程序，在KEIL上调试仿真通过。-I have to do to give the ST

C51常用字程序，单片及开发中的常用程序，缩小巧但很实用，而且包括的面很广，有很强的借鉴价值！-C51 characters commonly used procedures, and development of a single common procedures, and narrow the cleverest but very useful, but also the broad-based and has a strong reference value!

以上程序使用PIC12C508单片机，内部4MHZ时钟，4脚输入50HZ脉冲信号，7，6，3脚（GP0，GP1，GP4端口）为输出口。其中渐变部分是让灯慢慢的变亮（或灭--It uses PIC2C508 SCM, 4MHZ clock, 4 port is for inputting 50HZ signal, 7/6/3 port for output.