其中包含了单片机与5045芯片的通信，读出字节，写入字节！还有单片机的内部时钟定时器，中断等操作！...

c8051f的uart口的测试程序，用来测试c8051f单片机串口是否正常-UART c8051f the mouth of the testing procedures used to test whether the normal c8051f single-chip serial

风机控制器智能程序2,请大家自己使用,千万不外传!-Intelligent fan controller procedures for two, let us own use, do not Gaiden!

AVR单片机的EEPROM的读写程序, 通过TWI接口读写.-AVR MCU EEPROM reading and writing process, reading and writing through the TWI interface.

void InitGoertzel(void) 作用：初始化算法参数 用法：采用算法进行检测前执行一次，如果需要改变参数，调用SetParameter() float CGoertzel::GetMagnitude(unsigned char * sampleData, int length) //算法主接口 作用：对采集下来的音频数据用算法处理，返回一个结果 参数：sampleData－音频数据缓冲地址指针； length-缓冲区尺寸(音频数据数量),字节数； 返回值：返回算法结果。 void SetParameter(DWORD set_SampleRate, DWORD set_TargetFreq, DWORD set_BlockSize) 作用：设置算法参数； 参数：set_SampleRate-音频数据抽样速率； set_TargetFreq-目标信号频率； set_BlockSize－算法数据块尺寸(采样点)； 用法：调用本函数后，需要调用一次InitGoertzel(void)才会生效-void InitGoertzel (void) function: initialization algorithm parameters Usage: The algorithm performs a pre-test, if the need to change the parameters, calling SetParameter () float CGoertzel:: GetMagnitude (unsigned char* sampleData, int length)// Algorithm for the main interface role: to collect audio data from the treatment algorithm to return a result parameter: sampleData-audio data buffer address pointer length-buffer size (the number of audio data), number of bytes return value: the return of

点阵液晶取模取模软件，里面可以设置很多种方式，纵向取模与横向取模等可以适应各种LCD-Modulus modulus matrix LCD software, which can be set to very many ways, vertical and horizontal modulus modulus, etc., may adapt to a variety of LCD

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

PID-REGULATOR FUNCTION "C" SOURCE CODE

发射芯片nrf24e1的控制字配置，发射子程序 与单片机的通讯-Launch control chip nRF24E1 word configuration, launch communications subroutine with SCM

串口上的128X64的LCD源程序!已编译并调试通过!-serial port on the LCD source of the built! Compiling and Debugging has passed!

基于凌阳单片机的语音 手动 播放音乐 的 汇编程序-Sunplus based on single-chip voice manually play the music of the assembler