此为针对凌阳SPCE061A板进行的uCOS2.00版本的移植，编译通过且运行正常，自带一个LED灯的实验，可以直接看到效果。...

一个ucos-ii2.51移植到gcc下的port.大概是一个韩国人做的。从UCOS网站上那个VC的port改进而来。使用和介绍请见RAR文件中的注释。-an CENTER-gcc ii2.51 transplanted to the port. About a Korean done. UCOS site from which VC improvement from the port. The use and presentation of RAR see the Notes document.

UCOS-II FOR STM32F103XX 1 本程序是我自己移植，只使用KEIL进行过软仿真，测试没有发现问题。支持从任何一个中断服务程序里释放信号量。 2 此代码作为参考和学习使用，如果在使用过程中造成损失，本人不负任何责任。 3 此代码作为参考和学习使用，因为里边有UCOS-II，如果要作为商业使用请给UCOS付费。-UCOS-II FOR STM32F103XX 1 This procedure is my own transplant, carried out using only soft KEIL simulation, testing did not find the problem. Support from any one of interrupt service routine release semaphore. 2 of this code as a reference and learning to use, if in the use of the process of loss, I no responsibility. 3 of this code as a reference and learning to use, because inside has UCOS-II, if we as a commercial use, please pay uCOS.

Linux物理内存分配方法:伙伴系统算法原码-Linux physical memory allocation method : Partnership original algorithm system code

UCGUI3.32版本的使用手册，注意了，不是网上常见的32404版本，要的快下：）-UCGUI3.32 version of the user manual, attention is not on-line version of 32,404 common to the quick :)

在iar for stm8里移植了ucos ii 2.54版本，是上官金虹大侠的大作。(In iar for stm8 in transplant ucos ii 2.54 version, is the masterpiece Shangguanjinhong heroes.)

一本关于uCOS-II的经典教程，特别适合嵌入式系统开发的人员学习。-one of uCOS-II classic handbook, particularly for embedded system development study.

linux下的RTL8019驱动源码-the RTL8019 driver source

UC OS文件。在BC下运行的源文件。。。ucos源代码。-ucos

完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。 -Completed the processor S3C2410 transplant μC/OS-II kernel, and then multi-task to achieve the following: a) control experiment box core board 4 bright LED lights out rotation b) will LED1 connected to the ARM9-2410EP enhanced experimental me expansion of the mouth of DA OUT port, through the experimental box on your keyboard (such as