Just learn to control that PC, I feel pretty good this procedure is suitable for...

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

this is a source code for usinf sd card with PIC

本程序实现了对MOTOROLA08AS20单片机EEPROM的访问，可自动配置波特率，实现了对EEPROM的读、写和擦除操作。-This procedure MOTOROLA08AS20 realize single-chip EEPROM of the visit, can automatically configure the baud rate, to realize the EEPROM read, write and erase operations.

有Proteus 7.1电路与LED倒计时C51程序,可以软件仿真C51的程序状态. -Proteus 7.1 has circuits and LED countdown C51 procedures, can be software simulation of the procedures the state of C51.

89s51单片机控制的键盘和led系统，键盘送数led从低到高位的显示-89s51 MCU control of the keyboard and led system, the keyboard to send a few led from low to high Show

8051系列变速器简介

基于AVR系列单片机MEGA8的PS2键盘驱动程序，代码中加了去抖动处理，识别率高。 -based MCUs MEGA8 PS2 keyboard drivers, code added to jitter, high recognition rate.

xc164cs_adc xc164cs的AD转换程序-xc164cs_adcxc164cs the AD conversion process

液晶显示器LM24064的驱动程序，可能支大家有点帮助。-LM24064 LCD driver may support a bit to help everyone.

此包包括以HD4478位控制器的LCD说明，另外有一89c51为例，采用直连方式编写的lcd驱动程序，效果为将要显示字符以左滚动方式双行显示，难度不大，但体现部分原理，水平不高，共同进步！-HD4478 to the LCD controller note, another example of a 89c51, with Direct Connect approach to the preparation of the LCD driver and the results will be revealed for the characters to the left of double rolling basis, not more difficult, but embodies some principles, the level is not high, and common progress!