This procedure used to realize single

51单片机上的DS1302驱动，相关的LCD驱动可以在我发布的其它驱动中找到。-51 MCU on the DS1302 drive LCD driver can be related to the other drivers I have found.

6位数码管显示的频率计，外部方波接到P3.4（T0），测试通过-6-bit digital tube display of the frequency counter, the external square wave received P3.4 (T0), the test

液晶显示模块。在lcd上显示数字的函数。-display of the lcd

基于DS1820温度传感器,单片机控制的单线多路温度检测-Based on the DS1820 temperature sensor, single-chip microcomputer-controlled one-way multi-channel temperature detection

C8051F040红外编码解码主程序能处理大部分红外遥控器对红外指令连续发送两次以上的遥控器有效，红外指令代码须小于54位-C8051F040 infrared codec main program can deal with most infrared remote control for sending commands to the infrared remote control more than two effective, infrared command code to be less than 54

x25045的编程应用（51汇编格式），它具有512字节的EPROM，看门狗，复位信号等，是MCU不错的外围芯片 -x25045 application programming (51 Series format), which has 512 bytes of EPROM, the watchdog, the reset signal is a good external MCU chip

DS18B20温度测量，上下限温度设定测量（超出报警）-Upper and lower limits of temperature measurement (in excess of the police)

STC89C58加18B20温度传感器构成的温度采集器程序-18B20 increases STC89C58 temperature sensor consisting of temperature acquisition program

实现了对红外遥控器的解码及响应，并能进行LCD显示。-Realize the infrared remote control decoder and response, and can carry out LCD display.

C51程序-C51 procedures