电风扇，带遥控功能，可通过遥控实现转头，换档等功能。

C8051f020从ISD4004分段地址0000H 开始放音，再连续放音120秒后停止放音-C8051F020 from sub-ISD4004 Address 0000H to start playback, then playback for 120 seconds after the playback

c8051f020 内部12位的ADC0 效果比较啊好,调通了 如果不行 我还有其他人写的一个程序.我传的代码都有比较爱完整的注释啊-C8051F020 within 12 compared the effect of the ADC0 ah well, if the transfer had not I still have other people write a program. I have compared the code Chuan Love Notes integrity ah

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

北京大学的单片机教程，ppT文件，要学的可以自学，-Peking University microcontroller tutorials, ppT documents, to learn to self-learning,

DS18b20温度计,可以检测温度的变化，精度高-ds18b20

msp430单片机控制输出PWM波,可以用来控制DC_DC变换用的控制信号,很好用-MSP430 single chip microcomputer to control the output PWM waves, can be used to control DC_DC transform the control signals used, very good use

测试LCM模块AVR应用，ICCAVR编译器编辑。-AVR application testing LCM module, ICCAVR compiler editor.

单片机发生的讲解，不懂得可以看看!-the SCM talks, do not know how to look at!

直流电机的开环控制c51远代码，调试通过，放心使用。-DC motor control of open-loop far decoder code debugging through reassured use.

用单片机汇编语言写的使用的子程序 包扩浮点书的加减还有 模糊算法-SCM assembly language used to write the use of the subroutine package expanding the floating-point addition and subtraction algorithm still fuzzy