基于菲利蒲LPC2132PWM功能的实现,

avr单片机程序。实现按键控制发光二极管。每按一个键就能使对应的灯亮-avr microcontroller program. Achieve the keys to control light-emitting diodes. Each press of a button can make the corresponding lights

采集端程序，可以搜所电信号，每次可以采集32个信号，可以用于检测信号好差。-acquisition software, can be found by the electrical signal that can be collected each 32 signal can be used to detect bad signal.

1602 的驱动程序 很完整。通过KEIL C 编译在ROTUES 上用AT89C51仿真通过。-1602 is a complete driver. Through the KEIL C compiler ROTUES used in the simulation through the AT89C51.

十路无线智能器抢答器的程序源代码，功能基本都考虑到了，包括倒计时启动和暂停，终止，重启，倒计时设定-10 Lu wireless smart device Responder program source code, the basic functions are taken into account, including the countdown to start and be suspended, terminated, restart the countdown settings, and more

介绍了无线传感器网络的路由协议的研究进展，安全性研究，以及仿真的研究。-Introduced a wireless sensor network routing protocol research, safety research, as well as simulation studies.

PIC单片机4*4键盘扫描C语言程序-PIC single-chip 4* 4 keyboard scan C language program

关于89c51驱动tcp/ip的驱动程序。包括了对tcp/ip转换为rs232协议输出-on 89c51 drive tcp/ip drivers. Including a pair of tcp/ip converted to RS232 output agreement

CAN总线调试通过的程序，SJA1000芯片的Peli CAN模式下的C51源程序-CAN bus debug the procedure adopted, SJA1000 chip Peli CAN mode source of C51

KEIL ISD51 中文说明 ，配合Keil uVision2 方便-KEIL ISD51 Chinese explanation, with convenient Keil uVision2

本文件为atmel公司的at45db芯片的驱动程序实例,对于串行flash编程有帮助-this document for the at45db ATMEL chips Driver example, serial flash programming for help