存取聚苯乙烯/ 2键盘接口

ds1820或ds18b20读取序列有明显不同的程序，可在线读取多个芯片的序列码。

流水灯,用于熟悉了解单片机,初次上手的人用-Water lights, used to become familiar with single-chip, first-to-use with

有一个菜单的窗口，窗口口有文本区组件，菜单有打开菜单，当点击该菜单项，在窗口中打开文件-Click on the open. This will download the file in a new browser window, so that you can check the contents

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

这是一个，51单片机的脉冲采集器的程序，可以用KEIL C环境下编译，也可以使用WAVE软件，运行非常稳定-This is one of 51 single-chip pulse collector procedures, can be used KEIL C compiler environment, you can also use WAVE software, to run very stable

本程序可以利用74164串入并出芯片在七段共阴数码管上依次点亮0至9十个数字.. PA0....数据 PA1.....CP PA2.....是位选 在ATMEGA644P上调试通过-This procedure can be used to string 74,164 and a total of a chip in the seventh followed by vaginal digital tube light figures 0-9 10 .. PA0 .... data PA1 ..... CP PA2 ..... is selected through ATMEGA644P debugging

正转，转四相步进电机，每相间隔70ms。C51程序 51单片机通用。-Is to switch to four-phase stepper motor, each interval of 70ms. 51 Single-chip Universal C51 procedures.

LCD常用取模软件,还行-LCD common modulus of software, but also line

环境是IAR,本实例应用于大棚或是其他需要温度控制的场合，可以供大家参考一下。-Environment is the IAR, the examples used in greenhouses or other occasions the need for temperature control, you can refer to for everyone.

LT_1B msp430开发板例子程序－UART11_19200_2