此C语言程序实现串行接口电压输出型D/A转换器MX532的控制。

使用dsPIC33FJ256GP710的增强型CAN通讯，即ECAN的使用。-DsPIC33FJ256GP710 enhanced the use of CAN communication, that is, the use of ECAN.

Philips单片机P89C51RD和西门子Profibus工业总线的接口程序,硬件是鼎实公司的实验板,使用的鼎实公司的总线桥.-Siemens Profibus and Industrial Access Bus export procedures, hardware Teijitsu board of the company, using the company"s Teijitsu Bus Bridge.

X5043读写程序，非常少见的可以直接调用的源代码，对你非常有帮助-X5043 to read and write procedures, very rare direct call to the source code, and for your very helpful

SST28SF040是SST公司推出的高速可编程闪存。它具有512k*8的存储结构 芯片擦除及写入的时间快,可靠性高,能够重复写100,000次,低功耗.以上程序是用c51编写的驱动程序，希望对使用该芯片的同仁有所帮助-SST28SF040 SST is the company"s high-speed programmable flash. It has 512k* 8 storage structure chip erase and write the fast, high reliability, write to repeat 100,000 times, low power consumption. The above procedure is used to prepare the decoder drivers, and I hope to use the chip colleagues help

这是一个车用电机调速器的AVR单片机的整套C语言的源代码，实用工程。-This is a motor vehicle s AVR MCU package of C language source code, and practical engineering.

msp320F247单片机的AD采样及液晶1602显示-msp320F247 SCM AD sampling and liquid crystal display 1602

基于C8051F330的24c04测试程序 利用I2C接口直接对其读写-24c04 based on the C8051F330 the test procedure using I2C interface to read and write directly

蜂鸣器报警程序 功能：蜂鸣器模拟报警器发出报警声音 用C语言编写的-Buzzer alarm program features: analog alarm buzzer alarm sounds written with C language

spi prog for mcu ok in keil C

这是我画的步进电机通用的驱动板，当然只是应用到初学者，版胡德不是很好，希望大家多多指教。-This is my painting of the stepper motor drive GM board, of course, only applied to the beginner, not a very good version of Ehud, I hope everyone exhibitions.