-
液晶方面的一些资料文件 希望有所帮助关于51语言
液晶方面的一些资料文件 希望有所帮助关于51语言-LCD some hope that help information paper on the 51 language
- 2022-04-27 07:36:08下载
- 积分:1
-
STC单片机IO口模拟RS232测试程序,Keil Cx51应用开发技术中的程序主要的功能是在利用串口调试工具发送一个8bit的数据,而后单片机接收后把这个数据...
STC单片机IO口模拟RS232测试程序,Keil Cx51应用开发技术中的程序主要的功能是在利用串口调试工具发送一个8bit的数据,而后单片机接收后把这个数据发送给模拟串口-STC Single-chip analog IO port RS232 test procedures, Keil Cx51 technology application development process is essentially the function is in the use of serial debug tools send an 8bit data, and then after the single-chip receive the data sent to the simulation of serial
- 2023-03-24 09:20:03下载
- 积分:1
-
这是一个旋转传感器的资料。通过可以设计remote mouse for computer....
这是一个旋转传感器的资料。通过可以设计remote mouse for computer.-this is a cell which can detect the whirl.
- 2022-01-26 01:58:45下载
- 积分:1
-
51系列单片机控制的微打驱动程序
51系列单片机控制的微打驱动程序-51 series monolithic integrated circuit controls micro hits the
driver
- 2022-10-20 22:00:03下载
- 积分:1
-
通过电脑串口读取传感器数据并进行实时显示
通过电脑串口读取传感器数据并进行实时显示-Via the computer serial port to read sensor data and real-time display
- 2022-03-14 07:26:33下载
- 积分:1
-
AT89C51中文资料。AT89C51的8引言
AT89C51中文资料。介绍了AT89C51 8位单片机的内部结构和各个存储器,时序等。-AT89C51 Chinese data. Introduction of the AT89C51 8-bit MCU s internal structure and the various memory, timing and so on.
- 2022-01-26 02:16:41下载
- 积分:1
-
胡家荣(hjr7581@163.com)用KEIL写的的几个LCD、串口等方面的程序
胡家荣(hjr7581@163.com)用KEIL写的的几个LCD、串口等方面的程序-Hu Jia-rong (hjr7581@163.com) with KEIL wrote several LCD, Serial procedures etc.
- 2022-02-28 15:21:18下载
- 积分:1
-
液晶显示器(液晶显示
液晶显示器(LCD液晶显示面板)和LCD模块(LCM液晶显示模块)的开发与设计
- 2022-03-17 00:24:08下载
- 积分:1
-
STC89 Series MCU with generic IO simulation SPI communication FOSS
用STC89系列单片机的通用IO模拟SPI通信源码-STC89 Series MCU with generic IO simulation SPI communication FOSS
- 2022-07-25 23:29:44下载
- 积分:1
-
急救车与交通灯)(1)南北与东西方向,每个方面由红黄绿三个灯控制(2)南北向: 红(30秒),黄(5秒),绿(25秒) 东西向: 红(35秒),黄(5秒),...
急救车与交通灯)(1)南北与东西方向,每个方面由红黄绿三个灯控制(2)南北向: 红(30秒),黄(5秒),绿(25秒) 东西向: 红(35秒),黄(5秒),绿(25秒) 上述基本参数可以根据实际情况自行调整,灯的变化规律与实际路口规律相同,绿灯在最后5秒钟时,黄灯亮,然后红灯亮,不允许两个方面同时亮绿灯。(3)绿灯的时间显示在数码管上进行显示。(4)可以通过一个开关控制,当开关信号为0时,整个交通灯全灭提高要求:(1)设计一个紧急控制开关信号,当紧急开关信号为1时,两个方向的灯全为红灯。紧急开关撤消后,按照开关按下之前的状态继续运行(其参数要保存)。(2)设计一个夜间行车开关,当开关按下后,两个方向都只有黄灯闪烁,其它灯熄灭。(3)设计两个方向的亮时时间可调。-emergency vehicles and traffic lights) (1) North and South and east-west direction, each with three yellow-green from red lights control (2) to the north and south : red (30 seconds), yellow (5 seconds), Green (25 seconds) to things : red (35 seconds), yellow (5 seconds) Green (25 seconds) above basic parameters can be adjusted to the actual situation, the light changes with the actual law of the same intersection, the green light in the final five seconds, the yellow light is on, and then a red light, bright, not two fronts simultaneously bright green. (3) the green light at the time displayed on the digital display control. (4) can be controlled by a
- 2022-01-22 01:28:42下载
- 积分:1