PIC16(17)系列单片机原理和应用

X5043读写程序，非常少见的可以直接调用的源代码，对你非常有帮助-X5043 to read and write procedures, very rare direct call to the source code, and for your very helpful

CAN总线原理和应用系统设计-邬宽明 网评很好的一本书，电子版的很难找，CAN总线开发的经典教科书-Principle and Application of CAN Bus System Design- Wu Kuan-ming network assessment a very good book, the electronic version of the hard to find, CAN Bus development of the classic textbook

单片机控制的步进电机系统，包含keil51仿真和DXP原理图。-Single-chip stepper motor control system, including simulation and keil51 schematic DXP.

基于WAVE6000的 可以直接使用在数据采集系统中-based on the direct use of the Data Acquisition System

磁条卡读取代码，使用M2200进行开发的。 稳定，已经经过测试-Magnetic stripe card reader code, the use of the M2200 developed. Stability, has been tested

HD44780液晶驱动，KEIL C51-HD44780 LCD driver, KEIL C51

液晶t6963 24064驱动程序，直接调用可在屏幕上的坐标位置显示汉字，字符等，方便实现正显反显。-T6963 24064 LCD driver can be called directly on the screen coordinates of the location of display Chinese characters, characters, etc., facilitate the achievement is significant anti-significant.

P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7- P1.0 then LED L1 to L8, by using a timer internal microcontroller, a work by the way, every 0.01 seconds T1 interrupted an overflow. Simulation prepared timing control device. Boot 1 seconds L1, L3- liang, two seconds L2- L4, L5 three seconds, L7- liang, 4 seconds L6, L8-liang, 5 seconds L1, L2, L5, L7- liang, 6 seconds L2, L4, L6, L8- , 7 seconds 8-LED whole ... has been the cycle continues. 11.0592MHz fosc =

数字电压表,可模拟进行电压测量,用数码管显示电压值,有图和程序-Digital voltage meter, can be simulated for voltage measurement, digital display voltage value, a plan and procedures

这是一个电子电位器源代码,内有两种程序,一个是通过位操作,另一个是通过地址总线操作-This is an electronic potentiometers source code, there are two procedures, a bit through the operation, and the other is through the address bus operation