lpc2131工程模板 非常好 如何有需要用lpc2131开发的话，这个很好用...

2410芯片电路图，有关接口电路的设置，-2410 chip circuitry, the interface circuit of the setup,

基于linux操作系统ATMELARM9200 开发平台的键盘驱动程序开发-ATMELARM9200 development platform keyboard Driver Development

adc0809采集程序，led显示-adc0809 acquisition program, led display

一个基于ARM平台的触摸屏程序。-an ARM-based platform Touchscreen procedures.

keil for arm proteus

lpc2106 LCD demo. the demo is for use with yagarto and eclipse WinArm environment

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

DIY示波器大家都想要的我现在上传给大家-Oscilloscope DIY all the information that many people are currently engaged in this kind of DIY, From the information I hope to help these people!

STM32是以Cortex-M3为核的处理器，该例程介绍STM32下如何对IIC进行操作。IIC是一种通信协议，处理器可用来进行与外围接口的通信。-Cortex-M3 based STM32-core processor for the routine introduction STM32 how to operate on the IIC. IIC is a communication protocol, the processor can be used to carry out communications with the peripheral interface.

该PDF讲述了怎样在EWARM中进行开发stm32f10x系列，对初学者很有帮助。-The PDF describes how to develop in the EWARM in stm32f10x series of very helpful for the beginner.