游中国机器人I型探险车源代码

用at89s52单片机控制步进电机实现1/8细分，可用于太阳能充电电池集光板的设计-Using AT89S52 realize single-chip stepper motor control 1/8 Subdivision, solar rechargeable battery can be used to set the design of optical plate

EEPROM Writing Program EX. for AVR128

一个s3c44b0上的启动兼测试程序-a s3c44b0 start on the testing procedures and

将CAN现场总线移植到UCOS2中的驱动程序，在BC中调试运行成功-CAN fieldbus will be transplanted to UCOS2 the driver, were in BC successful operation Debugging

开关控制8个灯的亮灭-switch control eight bright lights to eliminate

单片机串口发数，通过串口调试助手可以显示，COM口为实际使用的，波特率设置为：57600

属简易型在线编程器，适合单片机初学者及低成本开发者，采用并行口方式对ATMEL89S51/89S52单片机进行编程，方便简捷。-Simple is an online programming, and suitable for beginners and low-cost single-chip developers, on the use of parallel port single-chip programmable ATMEL89S51/89S52 to facilitate simple and convenient.

ARM9.2的第二个程序-The second procedure ARM9.2! ! ! ! ! ! ! ! ! ! !

接收到的数据通过 UART 通信是在 SBUF 寄存器

61A的IRQ4中断有三个中断源：1KHz、2Kz和4KHz,每一个中断分别控制与IOA0-IOA1、IOA2-IOA3和IOA4-IOA7相连的LED灯。-61A of the IRQ4 interrupt has three interrupt sources: 1KHz, 2Kz and 4KHz, each interruption of the respective control and IOA0-IOA1, IOA2-IOA3 and IOA4-IOA7 connected to LED lights.