ISE7.1，采用VIRTEX

说明：  ? 熟悉IIC协议总线协议，采用IIC总线对图像采集传感器寄存器进行配置，并转换为RGB565格式。 ? 利用异步FIFO完成从摄像头输出端到SDRAM 和SDRAM 到VGA 接口各跨时钟域信号的传输和处理。 ? 利用 SDRAM 接口模块的设计，实现了刷新、读写等操作；为提高SDRAM 的读写带宽，均采用突发连续读写数据方式；并采用乒乓操作实现 CMOS 摄像头与VGA的帧率匹配。 ? 利用双线性插值方法实现对图像640×480到1024×768的放大操作。 ? 完成VGA显示接口设计。(Familiar with IIC protocol bus protocol, IIC bus is used to configure the register of image acquisition sensor and convert it into RGB565 format. Asynchronous FIFO is used to transmit and process signals across clock domain from camera output to SDRAM and SDRAM to VGA interface. With the design of SDRAM interface module, refresh, read and write operations are realized. In order to improve the read and write bandwidth of SDRAM, burst continuous read and write data mode is adopted, and table tennis operation is used to achieve frame rate matching between CMOS camera and VGA. The bilinear interpolation method is used to enlarge the image from 640*480 to 1024*768. Complete the VGA display interface design.)

说明：  基于FPGA，用verilog hdl语言实现串口收发实验(Based on FPGA, using Verilog HDL language to achieve serial port transceiver experiment)

说明：  document qpsk vhdl code

VHDL出租车计价器，包含所有代码及其仿真结果-VHDL Taximeter that contains all the code and the simulation results

这些代码为 对于基本的FPGA使用模块beep进行了例化 在工程 系统级建模时只需要直接调用就好了(The code for the basic FPGA using the module beep instantiated only need to be called directly in the engineering system-level modeling like)

fir低通滤波器 用于dspbuilder pll：25ns data 400khz sin 10.8khz-fir low-pass filter for dspbuilder pll: 25ns data 400khz sin 10.8khz

Verilog_HDL源码 -Verilog_HDL source Verilog_HD L FOSS Verilog_HDL FO

一个cpu的vhdl语言程序。非常好的 一个cpu的vhdl语言程序。非常好的-A cpu of the VHDL language program. A very good cpu the VHDL language program. Very good

按键控制LED流水灯；按键1按下前8个灯从左到右依次点亮，按键2按下中间前8个灯从左到右依次点亮，按键3按下所有灯全亮(Water control button LED lights sequentially lit buttons the eight lights left to right 1 Press button 2 press from left to right is lit in the middle eight lights, key 3 Press All full bright light)

MIG IP控制DDR3读写测试，于MIG IP核用户接口时序较复杂，这里给出扩展接口模块用于进一步简化接口时序。(MIG IP controls DDR3 reading and writing tests, and the time sequence of MIG IP kernel user interface is more complex.)