使用51单

小灯控制程序用51系列-small lights control procedures used 51 Series

MCS-51单片机应用设计-MCS-51 Application Design

开发板上跑的俄罗斯方块，有图片，源码。通过VGA接口输出。 -Development board to run the Russian box, has pictures, source code. Output through the VGA interface.

msp430 User Guideq.rar -msp430 User Guideq.rarmsp430 User Guideq.rar

汇编程序的一些非常实用的初始化程序-Compilation of some very practical procedure initialization procedure

基于中断控制的声光报警器的设计.采用中断方式，设计一个声光报警器的硬件电路和控制程序。程序运行时，一旦8位开关信号量状态满足设定条件，就触发中断，使发光二级管按规律闪烁，同时扬声器播放一段音乐。 硬件设备包括一台微机、一个MFID微机实验箱、一块T型板，2输入四与门 74ls08、8位总线驱动器 74ls245、LM386A音频放大器、排阻、扬声器各一个，发光二极管8个，470uF电容2个、104电容4个，插线若干。 -Interrupt-based control of sound and light alarm design. Using interrupt mode, designing a sound and light alarm hardware circuits and control procedures. The program is running, once the 8-bit switch signal to set the amount of state to meet the conditions to trigger interrupts, so that light-emitting diode flashes according to the law, while speakers play a piece of music. Hardware includes a computer, a computer simulation, MFID box, a T plate, 2 input 4 and gate 74ls08, 8-bit bus driver 74ls245, LM386A audio amplifier, exclusion, speakers of a light-emitting diode 8, 470uF capacitor 2 a, 104 capacitors 4, plug-line number.

基于msp430的液晶显示模块LCM141-MSP430-based liquid crystal display module LCM141

51单片机的资料，我没打开，不清楚能不能用。-51 SCM information, I never opened, can not use.

这是一个用于RS485通讯的协议转换程序,采用89S52芯片,KEIL 51开发-for RS485 communication protocol conversion procedures used 89S52 chip, KEIL 51 development

VC 编写的OPC客户端-VC prepared by the OPC client