-
使用NI M系列采集卡产品的DIO数字通道模拟I2C时序,读写EEPROM LABVIEW实例(原创),采用LABVIEW8.5编程。...
使用NI M系列采集卡产品的DIO数字通道模拟I2C时序,读写EEPROM LABVIEW实例(原创),采用LABVIEW8.5编程。-Use NI M Series DAQ card products DIO digital channel simulate I2C timing, read and write EEPROM device(original code), using LABVIEW8.5 programming.
- 2022-06-03 03:10:17下载
- 积分:1
-
我的一点点程序―红外解码程序
我的一点点程序―红外解码程序-A little bit of my process- IR decoding process
- 2023-02-25 04:45:03下载
- 积分:1
-
字母钟系统的实现代码,GPS卫星时钟对时的实现。汇编源吗
字母钟系统的实现代码,GPS卫星时钟对时的实现。汇编源吗-alphabetical system of code, the GPS satellite clocks on the achievement. Compilation source?
- 2022-04-28 18:27:03下载
- 积分:1
-
C51单片机
C51单片机模拟I2C双机通信协议,带从机部分。-C51 single-chip analog dual I2C communication protocol, with some from the machine.
- 2022-01-26 07:35:25下载
- 积分:1
-
msp430flash
msp430flash型单片机的封装库,呵呵,好东西-msp430flash- Packaging the MCU, what good things
- 2022-05-10 10:29:30下载
- 积分:1
-
AVR控制的SAB82525――HDLC通信
循环队列处理
完全是自己写的...
AVR控制的SAB82525――HDLC通信
循环队列处理
完全是自己写的-AVR control SAB82525-- HDLC communication cycle Queue processing is totally wrote it myself
- 2022-05-27 11:24:18下载
- 积分:1
-
DS18B20温度优越感器程序,是1WIRE的接口,可以学习这种接口的程序。...
DS18B20温度优越感器程序,是1WIRE的接口,可以学习这种接口的程序。-DS18B20 superiority temperature program is 1WIRE interface, this interface can learn the procedure.
- 2022-02-02 21:52:20下载
- 积分:1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作: AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位: 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位: 当CLK为低时,在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位,而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分:1
-
many procedures, sending messages Serial procedures.
好多51的程序,还有串口发送短信的程序。-many procedures, sending messages Serial procedures.
- 2022-03-03 03:29:39下载
- 积分:1
-
拉幕式数码显示技术,有详细的电路图以及C的程序
拉幕式数码显示技术,有详细的电路图以及C的程序-La-screen digital display technology, a detailed circuit diagram and the procedure C
- 2022-03-30 08:14:49下载
- 积分:1