是台湾松翰公司8位单片机编程器的英文使用说明。

基于18B20的多路温度采集系统-18B20-based Multi-channel temperature acquisition system based 18B20 Multi-channel temperature acquisition system based 18B20 Multi-channel temperature acquisition system based 18B20 Multi-channel temperature acquisition system

nRF2401芯片的各种资料以及pcb板图吐血推荐。-nRF2401 chips as well as various types of information recommended pcb board plans hematemesis.

AD转换用的很广泛的一款芯片的资料，觉得好分享了 大家用得时候可以尽管下！-AD converter is used in a wide range of information on a chip that everyone shared a good time can be used even though the next!

本文档详细的介绍了51单片机的程序设计方法-this document detailed account of the 51 Microcomputer Program Design

3972源程序 3972源程序-3972 source 3972 source code

LCD12864驱动开发，在KeilC51中非常有用

制版软件PROTEL99的封装库文件,-Engraving Software package library file PROTEL99

SD卡详细资料,包括SD卡介绍以及接口规范及部分电路连接图-SD card details, including the SD card interface specification and some of the presentations and the circuit connection diagram

arm7开发源代码杂集.包含有一些ARM7的开发代码-arm7 miscellaneous set of open source. contains a number of ARM7 Development Code

红外通信是利用950nm近红外波段的红外线作为传递信息的媒体，即通信信道。发送端采用脉时调制（PPM）方式，将二进制数字信号调制成某一频率的脉冲序列，并驱动红外发射管以光脉冲的形式发送出去；接收端将接收到的光脉转换成电信号，再经过放大、滤波等处理后送给解调电路进行解调，还原为二进制数字信号后输出。-Infrared communication is the use of near infrared 950nm infra-red as the transmission of information media, namely communication channel. The sending end when the use of pulse modulation (PPM) approach will be a binary digital signal into a frequency modulation of the pulse sequence, and driver fired infrared tube to the form of light pulses sent receiver will receive the pulse of light conversion to electrical signals , and then, after amplification, filtering and other treatment to the demodulation circuit after demodulation, reduced to a binary digital signal after the output.