Infrared remote control decoding digital display single

单片机编程的常用子程序，编程时候简单修改就可以使用。-Microcontroller Programmer common subroutines, programming time can use a simple modification.

easyarm 1138 用c语言开发的 2401无线 发送程序-easyarm1138 c 2401 send

大容量flash存储芯片nx25p40/80/16/32的单片机驱动程序，容量可以达到512K字节，1M字节，2M字节，4M字节。时钟速度可达50M。-large-capacity flash memory chips nx25p40/80/16/32 SCM Driver , the capacity could reach 512 K bytes, 1M byte, 2M byte, 4M bytes. Clock speeds of up to 50 M.

单片机内部定时器编程-Single-chip internal timer programming

这是一个键盘扫描的程序，相信想做毕业设计的同学非常想得到的哦，想要就看看吧，不好的话多提建议哦-This is a keyboard scanning procedures, wanted to believe that the students graduate design is the kind of oh, want to see it on, the poor more suggestions oh

RS485标准的C51通信程序，只要两个单片机和485芯片就可以实现通信-C51 standard RS485 communication program, as long as the two single-chip and 485 chip communication can be achieved

单片机波特率程序--Wave bit frequency program in SCM.

普通IO口模拟RS232串口 占用定时器0中断 在TH0,TL0中设置波特率的大小 注意不要开定时器0的中断，这里用的是查询方式-ordinary RS232 serial I simulated occupancy Timer 0 interrupt the switching, TL0 set baud rate to the size not to open the Timer 0 interrupt here with the inquiry

程序描述:红外遥控RC5码解码程序,经串口发送 目标cpu:lpc932 晶振:11.0592M 硬件描述:一体化接收头接P20.指示LED接P26 编译器:KEIL 7.05 作者:刘玉宏(liu1234)-Description: RC5 infrared remote control code decoding process, by the serial port to send the target cpu: lpc932 crystal: 11.0592M Hardware Description: integrated access to receive the first P20. Instructions LED then P26 compiler: KEIL 7.05 Author:刘玉宏(liu1234)

使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管， P1口输出段码，P3口扫描，最高位指示通道（0-7）。-AT89C52 single-chip microcomputer use, 12MHZ crystal, P0 I read into the AD value, P2 for the AD population control, with a total of Yang LED digital tube, P1 port output above code, P3 port scan, the maximum bit instructions channels (0-7).