短信息相关单片机GSM短消息控件

NXP的mifare ultralight　数据手册, 英文版本,完成对电子标签的操作.-NXP" s data mifare ultralight manual, English version, the completion of the operation of electronic tags.

在winavr上调试的一个adc程序，可测试。-In a winavr debugging adc procedures, can be tested.

实时时钟RTC4553的测试程序，编译环境为伟福6000，汇编程序-real-time clock RTC4553 testing procedures, compile environment for the 6,000-fu, assembler

PCF8563T串行时钟芯片的驱动程序，需要I2C总线的接口函数。-PCF8563T serial clock chip-driven process that requires I2C bus interface functions.

汉字液晶显示LCM 160X2的控制源程序，针对各种PIC单片机。也可对其它单片机参考-Chinese character LCD LCM 160X2 source control, targeting a variety of PIC. It can reference other MCU

0-99的计数器，带proteus仿真文件。-0-99 of the counter, with proteus simulation file.

基于MSP430的CO报警器的设计.有硬件电路,放大电路的分析,对做工业仪表人有帮助-MSP430-based CO alarm design. Have a hardware circuit, amplification circuit analysis, people have to help make industrial instrumentation

MAGIC2103-ARM7开发板中的UART源程序代码-MAGIC2103-ARM7 development board of the UART source code

avr 单片机 I2C总线设计原代码c程序设计-Single-chip I2C-bus design avr source code c programming

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention