MSP430F135 with OCM12232c

1.利用PWM控制占空比实现LED的亮暗。 2.可以用UP DOWM键进行控制亮暗。 -1. The use of PWM duty cycle control to achieve the bright LED dark. 2. Can be used to control button UP DOWM bright dark.

LT_1B msp430开发板例子程序－TA_7

欠过压报警电路的设计报告,ICL7100,模拟电路.-Toru 欠压agent changchu forlorn wind chirpy few forlorn rear cavity, ICL7100, Chang Yao-carrying wind.

12,14,16点阵汉字显示文件 12,14,16点阵汉字显示文件-12,14,16 dot matrix display Chinese characters files characters dot matrix display documents 12,14,16

将单片机的IOA0~IOA7分别接按键S1~S8连接到高电平上。此时，如果某个按键被按下，对应的I/O端口就会输入高电平进单片机，即按键S3按下，IOA2会输入高电平进单片机-Will Singlechip IOA0 ~ IOA7 access keys, respectively, S1 ~ S8 is connected to high on. At this point, if a button is pressed, the corresponding I/O port will enter into the high single-chip, that is, S3 button press, IOA2 will enter into single-chip high

电子图书《华中理工大学出的C51教材》，很不错的。-electronic books "Huazhong University of Science and the C51 materials," very good.

DDS 单片机控制AD7008 产生正弦波-AD7008 single-chip control of DDS generated sine wave

通过小磁片对霍尔传感器所产生的电平变化进行记数的C程序~-Hall sensors through the small disk on the level generated by changes in procedures for counting of C ~

MSP430框架程序。适用于MSP430F449，其他型号需要适当改变。 不使用的中断函数保留或者删除都可以，但保留时应确保不要打开不需要的中断。 保留中断函数，编译器将会为BSL密码填充所有的字节。-MSP430 framework procedures. Applicable to MSP430F449, other models need to be properly changed. Do not use the interrupt function can be retained or deleted, but should be retained to ensure that do not open unwanted interruption. Retain the interrupt function, the compiler will fill all of the BSL-byte password.

51单片机开发板，有数码管、按键、数模转换、液晶显示-51 MCU development board, with digital control, buttons, digital-analog conversion, liquid crystal display, etc.